if i move the amps to the Switched 12V+ of the suv and not the decks rem line

so the amp and eq are on the Switched 12V+ (what/where i'm going with the amps/eq get power off at or = the the deck)
how it is now the deck powers off as it power down it sends a power off to the eq/amps that = a pop

what would it do for the pop ?

 

ok it is not the deck

 

like someone else said you might just not have the soft on/off circutry in the amp.
my kenwood kac 7252 did this, as well as an old rockford, as well as an ultimate t21400, but a p3001 did not pop for me as well as a ultra linear 400W amp which was 45 bucks frox xs cargo and still going on 4 years strong... woo!

 

If you use a relay for your REM wire you can run all your equipment from one relay. It works by delaying power to the amps/whatever so you don't run into power up and power down problems. Another thing to check is your gains as some others mentioned.

 

that is not it
i has tried it
i have started lookin at all wires + and -
i have had more them one shop look at it
i just had a shop pop in a new alpine deck to see if it was it .........no not that
i think it mite be a bad - at the deck ............so i will look after my son goes to bed
gains are 0
the neg wire at the amps is 0 ohms
the neg wire at the eq is 0 ohms
poped in a new deck not that
i do not see the amps doing it but i mite try a new one soon

 

ok my neg wires are 0 ohms
if the eq and the deck are on the same power wire would/could this be bad ?
i'm at a loss with this

 

i was told to flip the power and rem power to the deck

 

Zinger talked about your amp not having soft on off circuitry. Test that hypothesis.

Simply disconnect the RCA wires to it will not receive a signal from anywhere else in the system. If it still pops, then you have the problem narrowed down to either the amp, or your ground (which I think that you have already addressed)

 

i did all that along time ago

 

it was my wiring harness had the 12v and the rem flipped