Remote Bass Boost Control Wires
#1
I have an Audiobahn Remote bass boost control that I want to wire into a system.
Can you use a cord designed for a telephones handset? The ends are the same, they plug into the amp and the remote, but I wanted to make sure the wires were not switched around somehow.
When I was looking at crimping up my own wires, the instructions stated that for a handset you reverse wires at each end. Is that the same situation for Audiobahn's wire?
Thanks,
Brad
Can you use a cord designed for a telephones handset? The ends are the same, they plug into the amp and the remote, but I wanted to make sure the wires were not switched around somehow.
When I was looking at crimping up my own wires, the instructions stated that for a handset you reverse wires at each end. Is that the same situation for Audiobahn's wire?
Thanks,
Brad
#3
Remote gains are not interchangeable between amplifier brands. You may risk damage to the amplifier.
Try to find a schematic for the original remote gain on the amp in question and make sure the one you have is identical internally.
Try to find a schematic for the original remote gain on the amp in question and make sure the one you have is identical internally.
#4
The remote is designed for this amp. They are both Audiobahn. All I need to know is if the cord from a telephone handset (smaller jack then regular phone)can be used or if you have to use the Audiobahn connection wire.
Thanks,
Brad
Thanks,
Brad
#7
Thanks guys. I finally got a reply back from Audiobahn about the cord. Of course they say that I should only use their official cord. That is what I expected to hear from them. They would not verify that the pins were wired the same.
Thanks again,
Brad
Thanks again,
Brad
Thread
Thread Starter
Forum
Replies
Last Post