series or parallel
#4
Actually no. It should be wired in series. if wired in parallel, there would be a 1 ohm load on the amp, and from what I remember the SRX3 is only 2 ohm stable...
if wired in series you would have a 4 ohm load on the amp, and the SRX 3 puts out 250w at 4 ohm. it's a 3 ch amp, do you have components, or any other speakers running of this amp?
Mark
if wired in series you would have a 4 ohm load on the amp, and the SRX 3 puts out 250w at 4 ohm. it's a 3 ch amp, do you have components, or any other speakers running of this amp?
Mark
#7
is it just the mid? the tweeter produces sound? if the tweeter produces sound, then I'd check the wire connection at the crossover, and then behind the HU (deck) and if they are connected as they should be, then there might be a break in the wire(s) or possible the mid is blown.. could be a number oif things.
Mark
Mark
Thread
Thread Starter
Forum
Replies
Last Post
OPPressed
General Discussion
6
09-24-2007 02:49 PM