sub in spare tire well suggestions
#1
i am putting a 12" sub in the spate tire well of my 88 mustang gt. i would like to know what are the options besides the obvious one of making a fiber glass enclosure. i am putting a 12 in the well and a 14'' x 9'' x 2 1/4'' amp in the back with distr. block and a stif. cap. so im trying to decide what kind of enclosure to go along with the very low floor so i can still have a hatch to put things in. its a blank slate right now and im just searching for ideas if you have any please post.
thanks for reading.
thanks for reading.
#2
Personally I would reccomend fibreglass because is the best way to create a clean and proper sealing enclosure, plus it alot easier to remove it this way. I went the other route which was basically to cut one piece of MDF and place it over the well and seal all the gaps around it wheich was very messy and very difficult and it still doesnt seal quite right. And the other problem I now have is that its quite permanent in the vehicle. You can check it out here http://www.sounddomain.com/memberpage/331507 .
Thread
Thread Starter
Forum
Replies
Last Post
Rockney
Enclosure Design & Construction Help
2
11-14-2006 10:13 AM