umm hey i got a ultimate t3 500d amp to a dual 4 ohm L7 and i have it hooked up and pounding real well just wondering if i have the amp wired right cuz there kind of weird. the amp is a mono channel amp but it has 4 terminals and i wired my L7 to a 2 ohm load and ran the wires out of a hole in the back of the box then sealed the hole but then when i had the 2 wires i just took them and put them in the farthest right terminals of the amp is there a better way of wiring it seeing as there is 4 terminals i dont know i have tryed contacting ultimate but they wont return my emails so i would just like to know if i have dont it right????
thanks

-Richard

 

go to this site and follow the wireing diagram that they have layed out here.
I just bought a t3 1000d and hooked up my 2 - 15" rf's to it.

http://www.ultimate-sound.com/products_t3_amplifiers.html

 

And how is the 1000????Did you love it as much as I said you would??? LOL

 

you know what ...i am likeing it so far but i had to wire it for 4 ohms as i need to upgrade my wireing
but so far so good.
i am debaiting on weather or not to go for the 1 ohm load just for burping it ....

 

It will take it ..I did a 1ohm burp for a 15" adire..It takes it

 

No thats right the two right terminals are the bridged terms

 

the t3 amps are so beautiful. I spent all day today puting in totally new wires for everything and wasn't going to finish so I ran my power wire from the battery outside and around into the window and hooked it up to my t3 1000D. Ooh boy. I was hopin it was red leds to match my theme but the blue is very pretty (in a manly way ). But I didn't know they were 1ohm stable!? I mean, I am sure they don't do that for daily driven but what kinda specs does the 1000d do at 1 ohm????