I have one RE se 10"

600W RMS
Dual 2 Ohms
Mounting Depth: 6”
Electrical Q Value -Qes: 0.46
Mechanical Q Value -Qms: 4.4
Total Speaker Q Value -Qts: 0.42
Free Air Resonance -Fs: 26.6 Hz
Equivalent Compliance -Vas: 31 liters
One-Way, Linear Excursion -Xmax: 18 mm
Efficiency -SPL 1W/1m: 83.2 dB SPL
Effective Piston Area -Sd: 310 cm^2
DC Resistance -Re: 2.8 ohm
Nominal Impedance -Znom: Dual 4 ohm
Thermal Power Handling -Pe: 600 W
Force Factor -Bl: 17.7

and for amp a jbl bpx 500.1

How would i go to tune this around 34Hz. i would like to have a square/rectangle port. and is it better to make the port follow the side of the box like in one of the pictures?

also, how could i make the boxes edges round like the RE box? would the box stil be as strong?