Looking to build a ported box for a single DD 9512. I have a us amps MD3 powering it. Im using 1" mdf as i already have a full sheet laying around, i would like a slot port. Ive been looking for a program to input my measurments etc. and have a cut out sheet i can just use to cut it all...Im just not sure of a good program. i have Winisd but it doesnt help me much.

h = 14in
l = 30in
w = 25in

Tuned to 35hz

Thanks for any help.
Kyle.

 

put it in a 2 cube box.

 

also works in a 1.7 cu/ft box tunned to 57 hz

 

if those are internal measurements make the port 14x4.5 x 22.5 deep

if they are external make the port 12x3.25x23.5

either one should work pretty good

I use WINISD

 

Thanks for the port dimensions...i used to have a web site where you can input your measurements, and it would calculate your box for you and would give you a colour template on what cuts you need to make and what sizes? this was for a vented box. Does anyone know what that site was? i lost it last time i formatted. Bassically im just unsure of how to cut the inside port walls and to what sizes thats all...if i decide to change the internal size of the box, bracing etc.

Thanks,
Kyle.

 

Here it is... props to hofulstrof for the post.

Free Ported Subwoofer Plans brought to you by Subwoofertools.com Forum