hi everyone im from the south africa.i have 2 targa tens (tg 252 sub 2000w rms dual 2, one of the top brands in sa).i would like to know whats the best box size for tens and also look at a port between 6" and 8".Amp im going to use is the targa tg 18d 2000w rms at 1 ohm.later goin 2 buy a big amp.want to build box for spl (stock 1 ).im drivin a toyota runx 2005 about resonant freq 55hz(corola hatch) thank you for all help

 

is there no one that wants help or give me advise

 

please guys can same give advise.just a startin point.thank you

 

In my experience I have seen that a good starting point for 2 10"s has been 1.5 cubic feet, with a 6" aeroport, @ a length of 15" to start off and reduce from there searching for your peak.
Now mind you this is a box strictly for SPL, I would not reomend this box for everyday bumping with music.
Good luck and let us know what you decide to do..

P.S. I recommend in that car subs firing up and port to drivers side..

 

The reason you're not getting many responses is because that brand..targa.. is not common in north america, nor is your specific vehicle.

 

Try the12volt.com they should have something there

 

thank you's very much for your replys and help

 

hi everyone i would like to use a 3.2 cf box. I think my sub are 0.1 cf each ,so i have 3 cf for the box.i want to use a external port two 6" ports. How long must i make the ports to tune them to 53 hz and i want it to peak at 55 hz .al your advise would help alot.thank you

 

i would like to try something like this

 

Your box is way to big. As I previously stated, for 2 10"s you should not go bigger than 1.5 cb.ft. I built a box just like the one I am advising you of and with 2 Crossfire BMF, and a Crossfire 1400 watt, and 1 Optima yellow top, did a 147.5db sealed on dash.
Thats my advice based on your requirements, but of course you are free to do as you please, just don't ask for advice if you don't plan in taking it into consideration.