box size for two 10"
#1
box size for two 10"
hi everyone im from the south africa.i have 2 targa tens (tg 252 sub 2000w rms dual 2, one of the top brands in sa).i would like to know whats the best box size for tens and also look at a port between 6" and 8".Amp im going to use is the targa tg 18d 2000w rms at 1 ohm.later goin 2 buy a big amp.want to build box for spl (stock 1 ).im drivin a toyota runx 2005 about resonant freq 55hz(corola hatch) thank you for all help
#4
In my experience I have seen that a good starting point for 2 10"s has been 1.5 cubic feet, with a 6" aeroport, @ a length of 15" to start off and reduce from there searching for your peak.
Now mind you this is a box strictly for SPL, I would not reomend this box for everyday bumping with music.
Good luck and let us know what you decide to do..
P.S. I recommend in that car subs firing up and port to drivers side..
Now mind you this is a box strictly for SPL, I would not reomend this box for everyday bumping with music.
Good luck and let us know what you decide to do..
P.S. I recommend in that car subs firing up and port to drivers side..
#8
hi everyone i would like to use a 3.2 cf box. I think my sub are 0.1 cf each ,so i have 3 cf for the box.i want to use a external port two 6" ports. How long must i make the ports to tune them to 53 hz and i want it to peak at 55 hz .al your advise would help alot.thank you
#10
Your box is way to big. As I previously stated, for 2 10"s you should not go bigger than 1.5 cb.ft. I built a box just like the one I am advising you of and with 2 Crossfire BMF, and a Crossfire 1400 watt, and 1 Optima yellow top, did a 147.5db sealed on dash.
Thats my advice based on your requirements, but of course you are free to do as you please, just don't ask for advice if you don't plan in taking it into consideration.
Thats my advice based on your requirements, but of course you are free to do as you please, just don't ask for advice if you don't plan in taking it into consideration.