Building First Box - How Does It Seems So Far?
05-01-2013, 01:34 AM
#1
0 Watt CAFz'r
Thread Starter
Join Date: May 2013
Posts: 2
Building First Box - How Does It Seems So Far?
Alright so I decided to build my first box, based on the recommended dimensions of my 2 Alpine SWR10d4's for best results.
What I have thus far is..
Box, will be separated chambers built with 3/4.
40" width
13.75" height
11.5" depth
Ports will be seperated inbetween the subs, at the middle, by a sheet of 3/4.
1" width
12.25" height
15.5" length for 37hz
Here's the manual for the subs as well. The numbers are a little different as I am modifying it to fit my trunk a little better. http://a248.e.akamai.net/pix.crutchf...500SWR10D2.PDF
Do these dimensions seem alright? Any feedback would be great
I also need to figure out how I'll make it look on the outside but that's for later haha
What I have thus far is..
Box, will be separated chambers built with 3/4.
40" width
13.75" height
11.5" depth
Ports will be seperated inbetween the subs, at the middle, by a sheet of 3/4.
1" width
12.25" height
15.5" length for 37hz
Here's the manual for the subs as well. The numbers are a little different as I am modifying it to fit my trunk a little better. http://a248.e.akamai.net/pix.crutchf...500SWR10D2.PDF
Do these dimensions seem alright? Any feedback would be great
I also need to figure out how I'll make it look on the outside but that's for later haha
Thread
Thread Starter
Forum
Replies
Last Post
slip
Install related
9
09-29-2011 05:56 AM
AAAAAAA
General Discussion
15
01-26-2011 10:07 AM
tbradley_2
Car Audio Technical Discussions
20
08-22-2008 09:52 PM
Hardcore Rock Superstar
General Discussion
13
06-04-2004 12:20 AM
