can someone help me design a ported box for my DD3512e for a f150 center console
#1
can someone help me design a ported box for my DD3512e for a f150 center console
with 1500 wrms going into it.. from a macrom amp? its a super crew, I dont want to have it under the back seat, as the amps will be there
its too hard for me to make a ported box to replace the center console. I dont have enough room for the sub to be rear firing with the port there too
I have what I think is alot of room.. external max's are 13-14"ish wide(between the seats)I can go 16" high(tall) and 32" long...
I would want the sub down firing, with the port out the rear I would like to have it around 40hz give or take a few hz
all I need are the cut dimensions.... I tried bass box pro, but its too hard for me to understand... if only I could go sealed... that would be easy...
is this possible?
its too hard for me to make a ported box to replace the center console. I dont have enough room for the sub to be rear firing with the port there too
I have what I think is alot of room.. external max's are 13-14"ish wide(between the seats)I can go 16" high(tall) and 32" long...
I would want the sub down firing, with the port out the rear I would like to have it around 40hz give or take a few hz
all I need are the cut dimensions.... I tried bass box pro, but its too hard for me to understand... if only I could go sealed... that would be easy...
is this possible?
Thread
Thread Starter
Forum
Replies
Last Post
myx_maniac
Enclosure Design & Construction Help
11
11-20-2009 10:24 PM
avidedtr
Enclosure Design & Construction Help
4
02-19-2008 02:52 PM