First box
#1
First box
Hi All.
I did this to play with my CNC router to see if there was a business opportunity rather than out of a great need for a subwoofer in the car (although that's a nice side benefit).
Here are all the parts laid out on the router table after being cut. All dimensions were held to 0.002 inch.
Now I just need to assemble it and get an amp...
Dropout
I did this to play with my CNC router to see if there was a business opportunity rather than out of a great need for a subwoofer in the car (although that's a nice side benefit).
Here are all the parts laid out on the router table after being cut. All dimensions were held to 0.002 inch.
Now I just need to assemble it and get an amp...
Dropout
Thread
Thread Starter
Forum
Replies
Last Post
Anon1mus
General Discussion
2
01-17-2016 02:55 PM