Alpine Type X box designs
#1
Guest
Posts: n/a
Anyone built enought that they know the secret box?
I'm planning on using a single 10" off a MRDM1000.. I may be convinced to use the 12" but the 10 looks alot more aggressive..
What Box design is going to blow minds?
Keep in mind I will aim for more low end extension and low frequency output..
ANY ideas?
I'm planning on using a single 10" off a MRDM1000.. I may be convinced to use the 12" but the 10 looks alot more aggressive..
What Box design is going to blow minds?
Keep in mind I will aim for more low end extension and low frequency output..
ANY ideas?
#3
Basic specs: http://iweb.alpine-usa.com/pls/admn/...in=10&p_more=y
T/S for the SWX-1042D:
Thiele/Small Parameters
Coil Height (Hvc) : 48.1mm
Cone Area (Sd) : 360sq. cm
D.C.Coil Resistance (Re) : 3.6ohm + 3.6ohm
Electrical Q (Qes) : 0.67
Equivalent Suspension Stiffness (Vas) : 17 liters(0.6cu.ft.)
Free Air Resonance (Fs) : 29Hz
Frequency Response : 24Hz - 200Hz
Gap Height (Hag) : 10mm
Impedance (Nominal) : 4ohm + 4ohm
Linear Excursion (X linear) : 19.1mm
Maximum Excursion (X peak) : 22mm
Mechanical Excursion (Peak-to-Peak) : 75mm
Mechanical Q (Qms) : 9.72
Sensitivity : 81 dB/W/M
Total Loudspeaker Q (Qts) : 0.63
Owner's manual: http://www.stylestandard.net/oswego/Rooms/RoomComponents/AssetView/MoreInfo?Document=com.webridge.entity.Entity%5BOID %5B4A836209BFAEEC4F93760AEA627FA384%5D%5D&Containe r=com.webridg e.entity.Entity%5BOID%5B260A178E17D1D411B08E00508B B8123D%5D%5D&component=
Hope that is a start, talk to Defro, he should have the goods on these subs.....
T/S for the SWX-1042D:
Thiele/Small Parameters
Coil Height (Hvc) : 48.1mm
Cone Area (Sd) : 360sq. cm
D.C.Coil Resistance (Re) : 3.6ohm + 3.6ohm
Electrical Q (Qes) : 0.67
Equivalent Suspension Stiffness (Vas) : 17 liters(0.6cu.ft.)
Free Air Resonance (Fs) : 29Hz
Frequency Response : 24Hz - 200Hz
Gap Height (Hag) : 10mm
Impedance (Nominal) : 4ohm + 4ohm
Linear Excursion (X linear) : 19.1mm
Maximum Excursion (X peak) : 22mm
Mechanical Excursion (Peak-to-Peak) : 75mm
Mechanical Q (Qms) : 9.72
Sensitivity : 81 dB/W/M
Total Loudspeaker Q (Qts) : 0.63
Owner's manual: http://www.stylestandard.net/oswego/Rooms/RoomComponents/AssetView/MoreInfo?Document=com.webridge.entity.Entity%5BOID %5B4A836209BFAEEC4F93760AEA627FA384%5D%5D&Containe r=com.webridg e.entity.Entity%5BOID%5B260A178E17D1D411B08E00508B B8123D%5D%5D&component=
Hope that is a start, talk to Defro, he should have the goods on these subs.....
#10
Guest
Posts: n/a
Hi Dukk [img]graemlins/wavey.gif[/img]
I never was one for enclosure design... I build sealed FIberglass boxes...
If I'm going to be happy with a single 10 or 12.. thats not going to cut it..
Gues I'll give Rino a call tomorow
[ August 15, 2004, 07:13 PM: Message edited by: Underdog ]
I never was one for enclosure design... I build sealed FIberglass boxes...
If I'm going to be happy with a single 10 or 12.. thats not going to cut it..
Gues I'll give Rino a call tomorow
[ August 15, 2004, 07:13 PM: Message edited by: Underdog ]