Amp confusion.
#1
I have a e10A22 that I will be running in a sealed box. According to ED's website this sub can handle 650/1300 watts but only up to 800 watts in a sealed box.
I believe I can run this sub at either 1 or 4 ohms. So my question is what is the best way to run it and what would be the best wattage rating to run it.
Eg.......800 watts RMS @ 1 ohm?
I believe I can run this sub at either 1 or 4 ohms. So my question is what is the best way to run it and what would be the best wattage rating to run it.
Eg.......800 watts RMS @ 1 ohm?
#4
Originally posted by Canadian GP:
Can I buy an amp that is rated at 1000 watts @ 1 ohm RMS and turn down the gain so I won't damage the sub?
Can I buy an amp that is rated at 1000 watts @ 1 ohm RMS and turn down the gain so I won't damage the sub?
but keep the gain down and everything should be a-ok!
#5
Yeah, if you get an amp that does 1000 x 1 @ 1ohm you just have to turn the gain down a bit. That would allow you headroom if you ever wanted to upgrade to a higher power handling sub and also the amp wont be working as hard to produce the power.
Good luck with the sub, that little thing is awesome.
Good luck with the sub, that little thing is awesome.
Thread
Thread Starter
Forum
Replies
Last Post