Amp Shuting Down
Guest
Posts: n/a
I Have 2 12" Re Audio Sx's Running On One American Bass 200.1 At 1.1 Ohm I Have Two 2 Gauge Power Wires Connected By Ring Terminals Into One 2 Gauge Wire Same On The Ground Wire Each Power Wire Is Fused 100 Amp By The Battery SAME THING HAPPENED WHEN I HAD ONE 4 GAUGE WIRE I HAVE ONLY ONE BATTERY AND NORMAL ALTENATOR
Last edited by simple992; Jun 10, 2006 at 08:27 PM.
Well if you do a search on big three you will find it. But basically its beefing up your Postive wire from your alt to the + side of your battery. A negative from your - side of your battery to the chassie. And a negative wire from your alt. bracket to the chassie. Its fine to have 2 gauge power but if your Ground wire from your battery to the chassie is 8-10 gauge then really 2 gauge power is point less.
50 Watt CAFz'r
Joined: Jun 2006
Posts: 50
could it be from turning it up too loud?
what Volt pre-amp output is your deck?
at an audio competition here about a week ago, my dad kept popping the breaker in his amp when he turned it up, he tweaked his system a bit, turned up some gains and stuff and now theres no more popping, but great volume.
i know that if your deck has too high volt of a pre-out, it can cause the breaker to pop fairly easily if you crank it.
hope this helps.
what Volt pre-amp output is your deck?
at an audio competition here about a week ago, my dad kept popping the breaker in his amp when he turned it up, he tweaked his system a bit, turned up some gains and stuff and now theres no more popping, but great volume.
i know that if your deck has too high volt of a pre-out, it can cause the breaker to pop fairly easily if you crank it.
hope this helps.
