Amp stuck in Protection mode
#1
Hey guys, I have a Earthquake PH 300.1 and recently the ground connection came lose and it went into protect mode. Now I tightened it and everything is hooked up fine but it wont come out of protect. Any suggestions would be appreciated. Thanks
#2
YOU BLEW UP AN EARTHQUAKE?!?! I didn't even know tha was possible!!! [img]graemlins/jawdrop.gif[/img] Take it out of the car, and bench test it. That is the easiest way to tell if it is the amp or not. (which ill wager a bet that it is.)
Thread
Thread Starter
Forum
Replies
Last Post
Lowrolla'
Install related
8
07-19-2010 03:13 PM
Murkys
Car Audio Technical Discussions
11
05-30-2009 02:07 PM