i just got my dynamat and started to pull the door panels off, but the window roll down thingy i cant seem to get off...its manual windows in a 96 civic hatch...do i just pull it out (its pretty strong) or what?

 

Should be a screw holding the roller thing onto the inside of the door.

 

i dont see any screws, and if there was one how can i get to it?

 

There's likely a u-shaped spring steel clip holding the window crank handle in place.

Gently pry up the edge of the crank handle where it meets the door panel and take a look underneath (you might also be able to just press down on the door panel around the crank to open up a gap to see into).

You should be able to see either the two open ends or the bottom of the 'U' - you may need to wind the window up or down a bit to get things lined up.

Once you've found the clip, use a screwdriver or a pair of needle nose pliers to push it (away from you) off the winder post, then you'll be able to pull off the handle.

To put it back on, slip the clip onto the handle (there will be a couple of grooves in the handle that you'll slide the open arms of the clip into), then just pop the whole thing (handle and clip) back onto the shaft it came off of.

Cheers,
--
Terry McG

 

If a screwdriver seems difficult, try using a rag or small cloth. Get one side of the clip jammed in it and pull it away, sometimes it's a lot easier.

 

Ok well i got it off, broke one side and figured it out on the other lol live and learn