Head Unit Fasteners
#6
I was referring to the DIN Mount screws that hold the dash kit on.
Thanks for the replies. I tried M5 and M6 Torx, M5 was too small and M6 was too big, I ended up finding some goofy 10-24 x 1/2 Phillips screws at Lowes that fit fairly well. I sanded them down to be doubly sure they don't exceed 8mm. Accounting for the 1/8th of plastic Im at about 7mm penetration. Only sanded excess material off the end to give me an extra half mil or so.
Not ideal but it'll do the job.
Thanks for the replies. I tried M5 and M6 Torx, M5 was too small and M6 was too big, I ended up finding some goofy 10-24 x 1/2 Phillips screws at Lowes that fit fairly well. I sanded them down to be doubly sure they don't exceed 8mm. Accounting for the 1/8th of plastic Im at about 7mm penetration. Only sanded excess material off the end to give me an extra half mil or so.
Not ideal but it'll do the job.
Thread
Thread Starter
Forum
Replies
Last Post