i am ordering a stealthbox for my 2012 ram megacab and it come with 2 10" jl w6v2 and i currently have a kicker ix 1000.1 , i am wondering if i will have to upgrade my amp or will the kicker amp have sufficient power to run these subs ? thank you

 

you should be good with that amp , are your subs dual 2 ohm or dual 4 ohm

 

thanks for the reply ,

specs for the stealth box are
"The Hard Data: Contains two 10W6v2-D4's in a sealed enclosure. 1200 watt power handling. Wired for 4 ohm mono. Installs behind driver's side rear seat. The seat folding function remains unaffected"

specs for each sub are
"Continuous Power Handling (RMS) 600 W
Recommended RMS Amplifier Power 200 - 600 W
Nominal Impedance (Znom) Dual 4 Ω"

amp specs are
"Power Specifications - Subwoofer Channel
RMS Power @ 4 ohms 550 watts x 1 channels
RMS Power @ 2 ohms 1000 watts x 1 channels
RMS Power @ 1 ohm Not Stable
Peak Power Output 2000 watts x 1 channels
Amplifier Specifications
Amplifier Class D
Number of Channels 1 - Mono
Total Peak Power Output 2000 watts
Total RMS Power Output 1000 watts
Maximum Input Gauge Size 4 AWG
Minimum Impedance Unbridged 2 ohms
Minimum Impedance Bridged Not Bridgeable
Speaker Level Inputs No
Preamp Outputs 1 pair
Built-in Crossover Low-pass (LP)
Low-Pass Crossover Frequency 50 - 200 Hz
Subsonic Filter 25 Hz
Signal-to-Noise Ratio 98 dB
Bass Boost 0 - 18 dB
Bass/Gain Remote Yes
Fan Cooled No
CEA-2006 Compliant Yes"

 

if its an option to find another amp , perferably one thats 1 ohm stable that will give you the best result , only reason because at 4 ohm you wont be seeing alot of power , otherwise would running a single sub setup be an option , with that coil config its almost certain that a 1 sub setup would outperform 2 because of the impedance