completly boggled with amp Clipping!!!!
#12
Guest
Posts: n/a
ok i am running dual 2 ohm rockford power hx2's.. they are new! i have tried running them series to 4 ohm, then parrellel to amp for a 2 ohm load! (recommened 2 ohm load)
--amp is visonik 4000xd---
i have tried running just running both subs in 1 ohm, 2ohms, and 4 ohms.. i have also tried just running only 1 woofer also eithe 1 ohm or 4 ohms! nothing makes a dofference
livin loud
--amp is visonik 4000xd---
i have tried running just running both subs in 1 ohm, 2ohms, and 4 ohms.. i have also tried just running only 1 woofer also eithe 1 ohm or 4 ohms! nothing makes a dofference
livin loud
#13
Guest
Posts: n/a
i just tried hooking up 2 of my high current audiobahn amps to check my electrical system, or anything else. It worked Perfectly..
actually at only running maybe 1000watts rms to each woofer at 2 ohms it POUNDED with those amps!
i wish i could get the visonik working!!!
livin loud
actually at only running maybe 1000watts rms to each woofer at 2 ohms it POUNDED with those amps!
i wish i could get the visonik working!!!
livin loud
#14
It's not clipping, it's going into protect. You're probably getting a low voltage, perhaps from your remote wire. Try contacting paul (lauf),
or chris (concept mustang) as these guys have had a lot of experience with these amps.
or chris (concept mustang) as these guys have had a lot of experience with these amps.
#16
Guest
Posts: n/a
ya i have upgraded my remote wire to 10 gauage wire, (probably overkill! but better to be safe then sorry) and connected it right to my main 1 gauage power wire to the battery! i just used a big 30amp home wall switch to turn it on/off! so that can't be the problem now.
Maybe these amps will only run at 14++ volts!!! because for street class my vehicle ahs to be off, which means it's only giving it 12.5 volts or so!! anyone know........??
i have also emailed paul, just awaiting response...
livin loud
Maybe these amps will only run at 14++ volts!!! because for street class my vehicle ahs to be off, which means it's only giving it 12.5 volts or so!! anyone know........??
i have also emailed paul, just awaiting response...
livin loud