Still cutting off.
#11
Originally posted by Lethal:
Turn off the Power IC (in the menu -> setup-> Power IC - on ~ off ) and try just running the sub at the louder volumes and see if it still cuts out. There may be a problem with your V-Drive. I do recommend (as was earlier stated) wire the constant and ground direct. I had to do it with my 9833 and used the same harness when I swapped to my 9835. I also added a cpu fan due to heat issues because of the trucks heating ducts running DIRECTLY behind the heatsink (almost touching).
Turn off the Power IC (in the menu -> setup-> Power IC - on ~ off ) and try just running the sub at the louder volumes and see if it still cuts out. There may be a problem with your V-Drive. I do recommend (as was earlier stated) wire the constant and ground direct. I had to do it with my 9833 and used the same harness when I swapped to my 9835. I also added a cpu fan due to heat issues because of the trucks heating ducts running DIRECTLY behind the heatsink (almost touching).
Its allmost like my deck is skipping, But the timer still ticks... is that a possibillity??? I mean it vibrates the hell out of the deck when i crank it. But see when i pull the deck out and hold it, it still does the same thing.
I swear it has to be skipping. The fact that it sometimes sais error afterward reminds me of a bad skip. Its just soo wierd. Why would it keep reading seconds if it was skipping?
Any thoughts about that?
Thread
Thread Starter
Forum
Replies
Last Post