opinion on sub to go with amp
#1
Right now I have a PPI amp that puts out 500w rms at 2ohm going to a JLW3V2-D4 wired for 2ohm, 350w rms, JL rates the sub at 500w rms MAX before it goes into the warranty void zone. I have read that putting the extra power into the sub isn't really giving it that much extra db anyways. Mainly I want my setup to last awhile without messing anything up. I have had the W3 in both a slot ported and sealed enclosure and favour the better SQ of the sealed over the loudness of the ported.
I want to upgrade but without hurting my pocket, I would also rather have 2 subs over 1 since my setup will also be for show. Everything on the amp is turned down to prevent any possible damage to the sub but would I be better off with say 2 subs rated at 250w rms, any suggestions on subs? I was thinking of the infinity reference series subs the are being liquidated on ebay, either 2 10's or 12's, do you think these would be louder in sealed than the W3 in a sealed? Any major problems with these since they are going like crazy on ebay?
Any suggestions on the situation would be helpful, thanks.
[ July 07, 2005, 12:02 PM: Message edited by: sevsev ]
I want to upgrade but without hurting my pocket, I would also rather have 2 subs over 1 since my setup will also be for show. Everything on the amp is turned down to prevent any possible damage to the sub but would I be better off with say 2 subs rated at 250w rms, any suggestions on subs? I was thinking of the infinity reference series subs the are being liquidated on ebay, either 2 10's or 12's, do you think these would be louder in sealed than the W3 in a sealed? Any major problems with these since they are going like crazy on ebay?
Any suggestions on the situation would be helpful, thanks.
[ July 07, 2005, 12:02 PM: Message edited by: sevsev ]
Thread
Thread Starter
Forum
Replies
Last Post
AAAAAAA
General Discussion
15
01-26-2011 10:07 AM
blackwidow2_5
General SPL
17
09-18-2008 03:00 PM