U-Dimensions or PG
#1
I have a pg 500.2out getting fixed and i saw a 1000x1 U-Dimensions it would go with my othere U-Dimensions that i have in my set up .the 1000w is over kill for one focal 27h 4 oms sub! the pg amp does go with my powergrid
what would you do for SQ?
what would you do for SQ?
#2
The U-Dimension amp wont make 1000 watts at 4 ohms either. It's designed to put out that power at 1 ohm. Wait till your amp gets fixed !!
Or if you really want the 1000 watts RMS - Use the X1200.1 Xenon PG amp - it actually makes 1200 Watts RMS at any impedance between 1-8 ohms.(same power no matter what load)
Call CEM - they have them - and the best part is that the price has been dropped !!
Show them some support and get a good deal to boot !!
Or if you really want the 1000 watts RMS - Use the X1200.1 Xenon PG amp - it actually makes 1200 Watts RMS at any impedance between 1-8 ohms.(same power no matter what load)
Call CEM - they have them - and the best part is that the price has been dropped !!
Show them some support and get a good deal to boot !!
#3
i do not like the look of pg amps this yr
what does that amp run at at 4oms
if i get a new pg amp i will get it next yr when the new one comes out and i will look at cems for that amp if i go that way
what does that amp run at at 4oms
if i get a new pg amp i will get it next yr when the new one comes out and i will look at cems for that amp if i go that way
Thread
Thread Starter
Forum
Replies
Last Post
LIGHTS OUT
General Discussion
2
04-04-2004 05:54 PM