Heya, Thanks for the help or just for checking it out.
Ive had this problem for ahwhile, i tested everything countless times and took my amp in and they say they work, i have three subs, one never used..
And it doesnt work either when the system is on..
I have a sloc *loc* hooked up to my left and right speaker on the two suicide
doors, toyota tacoma pickup truck. And it doesnt work..
When i originally installed the sloc, i put the two wires and connected, the amp started working but it was noisy, static, Coils good, and then stopped working
so i hooked up bolth sides left and right side and nothing happens..

Its a rca problem, im just wondering if this sounds like my loc is bad..
Everything els is good, i spliced ito my stock speakers.
Loc doesnt have a red power wire, just hooks ito the speakers...

Should i get a new loc? or is there somthing els that i can be missing

 

Can i hook the loc to the speakers or do they have to go to the decks harness?

 

LOC is fine off speaker wires anywhere. Make sure polarity is correct both sides. I just did an install and had a faulty PAC brand LOC, so it does happen. Make sure your RCAs are good as well as all the basics (solid ground, remote, power, etc.)