okay well i have an 05 chrysler 300c with the boston acoustics sound system(6 cd stack, wheel controlls, no nav). We are putting in a eclipse double din and have tryed both metra wiring kits to no avail. Both the nav harness and the non nav hrness get switched power but neither turn the factory amp on. my question is, has anyone bypassed into the factory amp and gotten this setup to work? if so how? ive done the newer rams this was back before the harnesses came out but never in a 300c thanks in advance.

George

 

no sound at all, i think the amp may be under the drivers side daash but not sure, any locations or wire colours would be rad.

 

Pac makes a harness that will plug in, still use the factory amp and gives you switched ignition as well.

 

C2R-CHY from PAC as long as it has the most recent firmware AND you must use a relay to trigger switched power (using the modules switched out to trigger a relay to turn on the deck).

You only use the rear inputs on the harness.

 

amp turn on was turning to be a waste of my time. Bypassed the factory amp and went straight to the speaker output wires off of the amp. works wicked. factory amps are the suck. wire colour are on directechs if anyone wanted to do it.