lilwill418

Headunit :
Kenwood KDC-MP208
Spec too long : http://www.crutchfield.com/p_113MP208/Kenwood-KDC-MP208.html?tp=5684&tab=features_and_specs


Front Speakers:
Boss Diablo 5x7
Dimensions
Product Height 5 inches
Product Width 7 inches
General Features
Model D57.2
Product Type Car speakers
Speaker type 5 x 7"
Speakers included 2
Design 2-way
Tweeter size 1 inches
Tweeter type Mylar dome
Woofer type Poly-injection cone
Woofer surround Rubber
Additional features 1" aluminum voice coil, 25-oz. magnet
Performance Features
Peak power 300 watts
Sensitivity 90 dB
Impedance 4 ohms
Frequency response 85Hz-20kHz

Rear Speakers:
Boss Chaos 6x9

o 6" x 9" 5-Way Multi-Axial Speaker System
o 80 oz. Magnet Structure
o 600 Watts PEAK
o 300 Watts RMS
o 4-Ohm Impedance
o 1-1/4" High-Temperature Aluminum Voice Coil
o Frequency Response : 45Hz~20kHz
o Sensitivity : 93dB
o Butyl Rubber Surround
o Red Metallic Poly Injection Cone
o Two 1/2" Super Piezo Tweeters
o 1" Polymide Dome Tweeter
o Mounting Depth : 3-3/16"

I don't have amp for the speakers and I would like to put one but i dont know how to did it. At high level its sound like and my front speaker got damage

Sub amp :
Kenwood KAC-6104D

Product Features

* Mono subwoofer amplifier
* 200 watts RMS x 1 at 4 ohms (300 watts x 1 at 2 ohms)
* Variable low-pass filter (50-200 Hz, 12 dB per octave)
* Preamp- and speaker-level inputs

Technical Details

* Brand Name: Kenwood
* Model: KAC-6104D
* Depth: 9.1 inches
* Height: 2.3 inches
* Width: 7.8 inches
* Weight: 4 pounds

and now the sub:
Rockford Fosgate P2 12"
12" 500W Dual 4-Ohm Subwoofer
Features:
12" Punch P2 4-ohm DVC Subwoofer
Anodized aluminum voice coil former
High excursion large roll surround
Insulated 16 AWG tinsel leads / dual 8 AWG spring compression wiring terminal
2" aluminum Voice Coil Diameter
60 oz. double stacked Motor
Linear spider
Massive double stacked magnet motor assembly
Parabolic triangular cone geometry support system
Precision stamped CRS basket w/ removable motor cover
Removable and reversible screw concealing ring
Mounting Depth: 6.125"
Rec. Sealed Enclosure: 0.85 cu. ft. (24.07 liters)
Rec. Vented Enclosure: 1.75 cu. ft. (49.56 liters)
Weight: 12.9 Lbs.
Priced per speaker
Subwoofers are usually come as a single speaker unless noted differently.

Technical Specification:
Sensitivity: 85.5 dB
RMS Power Range : 250 Watts
Peak Power Handling: 500 Watts
Impedance: Dual 4 Ohm
Low Frequency response: 20 Hz
High Frequency Response: 200 Hz
Diameter: 12 Inch

I have just 1 red and 1 white output on my cd player...

curtis0432

Ya everything looks correct. The only problem is that you wont be able to run the speakers of an amplifier because you only have one pre out.

PistonHead

The easiest solution would be to pick up a 4 channel amp that has RCA outputs. This will allow you to use your single set of RCA's on the 4 channel amp and then pass the signal on to your sub amp.

Your other option would be to use an RCA "Y" cable to split the signal before the amp and then connect to the 2 amps.

Hope that helps.

Later,
Brad