New 6x9s, 2 channels down to 1?
#1
New 6x9s, 2 channels down to 1?
So I'm replacing some 6x9s in a 1992 Bonneville SSEi, but the previous ones had 2 sets of amplified inputs running to them each, I'm guessing there's a stock crossover somewhere (but possibly it's integrated into the stock amp).
So of course these new Pioneer 6x9s only have one input, and I'm sure their own internal crossovers...
What's the best solution to this problem?
Thanks guys.
So of course these new Pioneer 6x9s only have one input, and I'm sure their own internal crossovers...
What's the best solution to this problem?
Thanks guys.
Last edited by aCiD; 08-12-2006 at 01:00 AM.
#2
Originally Posted by aCiD
So I'm replacing some 6x9s in a 1992 Bonneville SSEi, but the previous ones had 2 sets of amplified inputs running to them each, I'm guessing there's a stock crossover somewhere (but possibly it's integrated into the stock amp).
So of course these new Pioneer 6x9s only have one input, and I'm sure their own internal crossovers...
What's the best solution to this problem?
Thanks guys.
So of course these new Pioneer 6x9s only have one input, and I'm sure their own internal crossovers...
What's the best solution to this problem?
Thanks guys.
the only things that pops into my head is to try one set of wires at a time and see what happens.
#3
you could go with bi-amped 6x9's, if you can return your pioneers. Jbl power series are bi-ampable, but you will have to exclude their outboard cross overs. I would ensure that your system is bi-amped before doing this though. Another option, though it may void your warranty is to cut the tweeter leads in the 6x9 and attach them to the tweeter leads from the amp, and do t same for the mids. I've done this before with good results off an aftermarket amp, with your factory amp, you should know what you're doing before you try it as the tweeter leads may not be able to handle a lower impedance load.
Just a few ideas that may work for you.
Just a few ideas that may work for you.
Thread
Thread Starter
Forum
Replies
Last Post
alexdbest2000
General Discussion
11
05-22-2007 08:07 PM