hey people i have an older earthquake PH-D2 amp it was working fine for the longest time then i heard a pop and it blew the transistors so i ordered the proper exact transistors from the states for the amp and now the amp turns on but not sound is coming out ? so i was just wondering why this is and wut component cud be going wrong thank you.

 

It could be anything along the line up to where the transistor blew. Chances are most likely there is a bad trace on the board.

 

what exactly is a bad trace? im new to this fixin amps thing this is kinda my test dumby

 

Traces are the metal pathways on circuit boards that power, ground and other signals travel on, instead of wires.

I'm just saying it's a possibility at this point.