2x15" Home enclosure
#51
Since I am Using this in my house is there a possibility of building it out of hardwood plywood??? For looks Or would that be a bad idea, Also consider I dont have easy transport of MDF so If it doesnt make that big a difference then Id go PLy as its readily available to order through school
Last edited by snobro1808; 03-05-2009 at 05:51 PM.
#54
your school should be able to get MDF from the same supplier no prob
They usually use Baltic Birch for home boxes if they are to be made of plywood, but like toddy said if they can get ply they can probably get MDF, and that will save some $.
I asked and he said he has to get it froma diff supplier, so it willtake a while, and its not worth it for 1 or 2 sheets, sounds corny to me :S Maybe Ill have totell him its mandatory. But If not Ill try to find some "Baltic Birch" Any reasononing behind "BALTIC BIRCH" use??
#56
Finally!
So after a few months(ok maybe more then a few) I finished the box, I havent needed to sand it down or anything as Its just sitting nicely in my room, It pounds quite hard and the amp definitely underpowers it! I will make a video soon hopefully. The vent is a 4" PVC pipe, I will be closing up the hole and moving down to a 3" pipe so I can make it shorter with the same tunning. Just hoping port mach isnt to loud! :O hahaha the box is big enough to compensate for some of the moving air so It should be fine. Tell me what you think. I am also rnning a crossover going to the amp and cuts out all highs about 160 give or take some that are tunning to the sub channel. If anybody wants to take this box of my hands for a decent price let me know as I am planning on making a box that is 16x34x22 box for my moms sunfire. should fit perfectly into the trunk and hopefully it pounds
Hope everybodies summer is going great and all your builds are coming out nicely. Once I get my wiring kit, it would be nice to meet someone who has better knowledge of wiring and interiors who could help me out with install Email is m-dvorak@live.com
Hope everybodies summer is going great and all your builds are coming out nicely. Once I get my wiring kit, it would be nice to meet someone who has better knowledge of wiring and interiors who could help me out with install Email is m-dvorak@live.com
#58
#59
22"x22"x22" internal measurement MINUS the subs.
22x2
I would have preffered building abox that took roughly one short section of wall in the corner and building it 7ft high 30" out and 6 ft wide. Would be the ultimate box. Might be a bit awkward to get in and out of the room though. xP specially if it was made out of 1" mdf, MINIMUM.
Anybody know of a high excursion driver that you would recommend for home theatre. That is somewhat cheap.. =D
Thread
Thread Starter
Forum
Replies
Last Post
wasted911
General Discussion
7
05-04-2017 08:40 PM