bananax

sorry I posted it earlier in the wrong section!

I have a choice between the Kenwood KAC-8402 4ch and the MTX Thunder 4244 4ch amp for powering my speakers

I have some Punch components in the front, and orion co690 6x9s in the back.

which of these 2 amps would be better for my use? the MTX probably has more power, where as the kenwood has adjustable crossovers vs the pre-set ones on the MTX

installer

Which have the bigger fuse??? This will tell you which is the most powerfull, beside MTX is better than Kenwood. I will use a woofer, instead the 6x9.

bananax

Not looking for a sub
Just took one out actually

I don't care so much about power more about clearity

The x over is why I'm even asking about these two

installer

Then dont worry...any one will do it.

MTT

iTrader: (17)

If you have them both on hand, try them both and see which suits your needs better.

Personally I'd go with the one with the crossovers, but all else being equal I doubt you'll hear any difference at all.

gumby!

iTrader: (2)

x2!!!!!!!