lookin really good... did ya figure out the alt whine??/ what was ya gettin it from.... rca?!?

 

yeah what was that alternator whine a Bordeaux or a Chardonnay?

 

I don't have sound as of yet....With the 7200mkII I had it wired direct to the Batt/IGN and ground. This time around I choce to use a factory adapter and use the stock wiring. I believe this way will work. if not then I have to f'n clue!

I'll keep you posted

 

If it was a Bordeaux or Chardonnay I'd bet it would taste like ****

 

Aluminum is all cut with no loss of any limbs. For some reason the 3" rings were a P.I.T.A. I had to make 4 of them. The end result is good but not as clean as I'd like. FOZZZY any input on why? The circle isn't all the clean. I didn't do anything different from the 1's and 6.5's.

The 1" ring outer edge was cut with the router and inner circle with a circle bit. All the other rings were cut with the router.

Heading the tub then off to the drill press for some tapping.

Btw the propane heater can be purchased at Home Depot in the tool rental section....by far the best investment. 20 minutes and it's comfortable.

 

Nice work Ju...keep it up

 

Taping the L1, L3, L6...I tapped the Morel but the Fakin tap broke - off to Princess Auto - Hmmm tool shopping

 

I have to say, im excited to see how she is coming along!

 

Things have come to a complete Hault.....this will be the last post for this thread.....
I'll start a new one of the completed FIT....whenever I decide to finish it!

 

So from the pictures you have posted it seems like you pretty far along Jules, what else is left to do?