how would two diff amp sound in a system?
#12
for subs I am running 2 Memphis 1500D's with 2 12's for now cuz the subs are Duel 4 ohm coil's so if I just used one amp for both I would just get about 375rms a sub which would be a waste of a $1500 or so amp, so I am running each sub with its own 1500D amp and I am only running 12" Audiobahn Flame Q's when they blow or die or what ever I can get get some high end subs, cuz I will have had time to save up for some sweet subs...
#14
Kicker KX1200.1 is 1200 watts RMS.
And one of those amps per sub will deffinatly smoke it. I've been there and done that.
Im speaking from experience.
For a Daily Driver, 500 RMS per driver is more than enough to get them thumping good.
I used to have 2 12" L7's off ONE JL 1000/1 and nobody wanted to sit in my van.
L7's are rated at 750 RMS each, and 1500 Peak.
Sending each sub 1200 watts RMS EACH, for a Daily Driver set up, your askin to fry em. For Burps they will take it, but not for daily driving.
Sono You know I know what im talkin bout here!
[ March 06, 2004, 12:28 AM: Message edited by: djtrini_9 ]
And one of those amps per sub will deffinatly smoke it. I've been there and done that.
Im speaking from experience.
For a Daily Driver, 500 RMS per driver is more than enough to get them thumping good.
I used to have 2 12" L7's off ONE JL 1000/1 and nobody wanted to sit in my van.
L7's are rated at 750 RMS each, and 1500 Peak.
Sending each sub 1200 watts RMS EACH, for a Daily Driver set up, your askin to fry em. For Burps they will take it, but not for daily driving.
Sono You know I know what im talkin bout here!
[ March 06, 2004, 12:28 AM: Message edited by: djtrini_9 ]
#15
Originally posted by slow/n\low:
Or spend less on an amp to match the impedance your current woofers give.
Oh but you wouldnt have 2 1500d's [img]graemlins/headbang.gif[/img] because you need those.
Or spend less on an amp to match the impedance your current woofers give.
Oh but you wouldnt have 2 1500d's [img]graemlins/headbang.gif[/img] because you need those.
[ March 06, 2004, 07:20 AM: Message edited by: I'm a Memphis Man now ]
#16
Originally posted by DWVW:
Ma Gates doesn't run Kicker
And when she did, she did not use off the shelf L7's
Ma Gates doesn't run Kicker
And when she did, she did not use off the shelf L7's
the s10l7's on the beast were run at 8ohm(dual 4's)so they were seeing 700-900rms each depending upon impedance rise or drop. [img]graemlins/thumb.gif[/img]
I'AM running 2 zr1000's on a pair of s12l7's daily driven,just need to be sure not to play far below the port tuning as very bad things can happen.they are tough subs,and if you're competing db drag i would go 2000wrms per sub or higher.
[ March 06, 2004, 04:58 PM: Message edited by: Loud Brown Kicker Colt ]
Thread
Thread Starter
Forum
Replies
Last Post
hoponpop
General Discussion
3
03-21-2016 11:10 PM