Right sub box?
#11
Small Hijack (apologies): As long as you have the box design program open for the OP, any chance you could for me as well? I've tried using a few of the box programs, but I'm not that good at it yet.
I'll thank you in advance & hope you have the time.
Requirements: Hard, Loud, clean bass. No rumbly crap, I hate it. Is there such a thing as a ported box that doesnt rumble?
Subs rated for 350 wrms each (have 2) Amp is PDX1.1000 rated at 1197 wrms.
Space: Up to 40" wide, 22" long, 24" high. A bit bigger on height / width is ok. I prefer a wedge so the subs are firing at a 45 degree angle instead of into the back seat (small SUV Ford Escape)
Mat: 3/4 MDF except for baffle, 1" there.
Specs:
DIAMETER: 12" (300MM)
SENSITIVITY (2.83V @ 1M): 92dB
POWER HANDLING: 350WRMS (1,400WPEAK)
FREQUENCY RESPONSE: 23 ~ 400HZ
DIMENSIONS:
THIELE-SMALL PARAMETERS
VOICE-COIL INDUCTANCE @ 1KHZ: LEVC (MH). . . . . . . . 0.76
DRIVER RADIATING AREA: SD (IN2) . . . . . . . . 82.15
SD (CM2) . . . . . . . 530.00
MOTOR FORCE FACTOR: BL (TM) . . . . . . . . . 8.52
COMPLIANCE VOLUME: VAS (FT3) . . . . . . . . . 3.47
VAS (LITERS). . . . . . 98.30
SUSPENSION COMPLIANCE: CMS (μM/N) . . . . 245.00
MOVING M***, AIR LOAD: MMS (GRAMS). . . . 243.00
MOVING M***, DIAPHRAGM: MMD (GRAMS). . . . 236.00
FREE-AIR RESONANCE: FS (HZ). . . . . . . . . 20.60
MECHANICAL Q: QMS . . . . . . . . . . . . 7.35
ELECTRICAL Q: QES . . . . . . . . . . . . 0.49
TOTAL Q: QTS . . . . . . . . . . . 0.456
MAGNETIC-GAP HEIGHT: HAG (IN) . . . . . . . . . 5/16
HAG (MM) . . . . . . . . 8.00
VOICE-COIL HEIGHT: HVC (IN) . . . . . . . . 1-1/2
HVC (MM) . . . . . . . 32.00
MAXIMUM EXCURSION: XMAX (IN) . . . . . . . . . 1/2
XMAX (MM) . . . . . . 12.00
Again, just in case you have time to do it, thank you.
John
I'll thank you in advance & hope you have the time.
Requirements: Hard, Loud, clean bass. No rumbly crap, I hate it. Is there such a thing as a ported box that doesnt rumble?
Subs rated for 350 wrms each (have 2) Amp is PDX1.1000 rated at 1197 wrms.
Space: Up to 40" wide, 22" long, 24" high. A bit bigger on height / width is ok. I prefer a wedge so the subs are firing at a 45 degree angle instead of into the back seat (small SUV Ford Escape)
Mat: 3/4 MDF except for baffle, 1" there.
Specs:
SPECIFICATIONS
DIAMETER: 12" (300MM)
SENSITIVITY (2.83V @ 1M): 92dB
POWER HANDLING: 350WRMS (1,400WPEAK)
FREQUENCY RESPONSE: 23 ~ 400HZ
NOMINAL IMPEDANCE: 1 or 4 OHMS
VOICE-COIL DIAMETER: 3" (76.2MM)
DIMENSIONS:
THIELE-SMALL PARAMETERS
VOICE-COIL DC RESISTANCE: REVC (OHMS) . . . . . . 1.00
VOICE-COIL INDUCTANCE @ 1KHZ: LEVC (MH). . . . . . . . 0.76
DRIVER RADIATING AREA: SD (IN2) . . . . . . . . 82.15
SD (CM2) . . . . . . . 530.00
MOTOR FORCE FACTOR: BL (TM) . . . . . . . . . 8.52
COMPLIANCE VOLUME: VAS (FT3) . . . . . . . . . 3.47
VAS (LITERS). . . . . . 98.30
SUSPENSION COMPLIANCE: CMS (μM/N) . . . . 245.00
MOVING M***, AIR LOAD: MMS (GRAMS). . . . 243.00
MOVING M***, DIAPHRAGM: MMD (GRAMS). . . . 236.00
FREE-AIR RESONANCE: FS (HZ). . . . . . . . . 20.60
MECHANICAL Q: QMS . . . . . . . . . . . . 7.35
ELECTRICAL Q: QES . . . . . . . . . . . . 0.49
TOTAL Q: QTS . . . . . . . . . . . 0.456
MAGNETIC-GAP HEIGHT: HAG (IN) . . . . . . . . . 5/16
HAG (MM) . . . . . . . . 8.00
VOICE-COIL HEIGHT: HVC (IN) . . . . . . . . 1-1/2
HVC (MM) . . . . . . . 32.00
MAXIMUM EXCURSION: XMAX (IN) . . . . . . . . . 1/2
XMAX (MM) . . . . . . 12.00
Again, just in case you have time to do it, thank you.
John
Thread
Thread Starter
Forum
Replies
Last Post
mcdon
Enclosure Design & Construction Help
9
10-21-2009 05:12 PM
Meteora_LP
Enclosure Design & Construction Help
2
10-10-2006 03:24 PM