HELP! is my voice coil blown?
#1
HELP! is my voice coil blown?
OK I bought this IDMAX sub and just installed it. However to my surprise there is no output, the sub will distort (cone makes nosies) when the volume is turned up. I tryed it with two amps and the same thing. Its a dual voice coil sub, and if the coils are messed is there any way to fix, or should I buy a new sub?
Thanks.
Thanks.
#5
dual voice coil (2ohms each)
err....its wired in series (4ohms) - my bad
but ya i found out my voice coil is blown.
when I pushed the cone in by hand there was a “scraping” noise, felt as much as heard (voice coil is rubbing in the magnet gap), and now its stuck in place.
any suggestions on where to get this fixed?
err....its wired in series (4ohms) - my bad
but ya i found out my voice coil is blown.
when I pushed the cone in by hand there was a “scraping” noise, felt as much as heard (voice coil is rubbing in the magnet gap), and now its stuck in place.
any suggestions on where to get this fixed?
Thread
Thread Starter
Forum
Replies
Last Post
I LOVE XPlOD
Enclosure Design & Construction Help
0
05-05-2009 09:31 PM
Vanilla Gorilla
General SPL
10
12-19-2004 08:33 PM