My Build Log - Chevy Dually
#62
The pic of the welder and its settings was taken on purpose for Murilo. He had to use the Utube to learn how to use one and still I remeber he was still having issues.
attached I showed him what them are supposed to look like and he claimed they mean nothing till it breaks a 60. so in the one pic it shows a 160... lmao. The worst part was buffing that rust off, I had purchased the steel a year ago and after i decided to ditch that blazer it sat outside for 7 or 8 months till was put into this build.
attached I showed him what them are supposed to look like and he claimed they mean nothing till it breaks a 60. so in the one pic it shows a 160... lmao. The worst part was buffing that rust off, I had purchased the steel a year ago and after i decided to ditch that blazer it sat outside for 7 or 8 months till was put into this build.
Grinding the rust off the tubes outside at -10C, just another day, hehe.
Back then I only knew how to use the stick welder, I guess is too old-school for you?
When you find some torque on this gas-guzzler you can come here in Winnipeg for some testing. (told you to buy the 6.5L)
#63
Haha nice!
Grinding the rust off the tubes outside at -10C, just another day, hehe.
Back then I only knew how to use the stick welder, I guess is too old-school for you?
When you find some torque on this gas-guzzler you can come here in Winnipeg for some testing. (told you to buy the 6.5L)
Grinding the rust off the tubes outside at -10C, just another day, hehe.
Back then I only knew how to use the stick welder, I guess is too old-school for you?
When you find some torque on this gas-guzzler you can come here in Winnipeg for some testing. (told you to buy the 6.5L)
Ya the 6.5 might better on fuel but I thunk I got more. Horses from this gas pot
As for amp test ya it is sMe one and it must very well be a meter issue cuz those who have sd know that emf causes some inaccurate readings , but none the less I think the output is correct as there was alot of volume left on tunes Before clip lite come on
#64
#67
When your coming down for some test/tuning let me know!!! I got the Corona's waiting and Murilo better get that damned fridge going in his shop!!
#70
Well santa brought me some 3/4 X 1.5" flat for christmas. And I was alone at shop today and so between answering phones and sending guys out I managed to get one set drilled for top posts, drilled and tapped to anchor to top post and got 12 connections drilled and tapped. If I am lucky this weekend I will get a good start on the new year.... I have 6 lenths of 1X1 tube left to install, and hope that sunday will dispose of it. Pixs to come mid next week. If goes my way !